1. Touch screen display

Touch screen display as following

 

2. Touch screen’s screen switch description

 

1.Welcome interface

When you turn on the host at first time , it will jump out of the choice of language interface, select end customer’s required language, the system will record the user automatic language selection, when second time to enter the system, the welcome page will be displayed and directly jump to the corresponding language environment, if users need to change the language, the language can be re-selected on setting page.

2.Operating state interface

The state interface is a table that shows the operating parameters of the light source. Display contents include channel running state, running mode, working intensity, running time and working temperature.

 

Eight Channels Running Interface Second Page

Error pre-warning interface

The current interface used to display a number of LED error messages, when the error mark behind the listed projects was lighted, the user need to contact our company to help eliminate the trouble and ensure the normal operation of the device.

 

EightChannels Pre-warning Interface

Set main interface

Enter the main interface by initial password (1234), in the settings of the main interface, users can choose the language , restore the factory settings, modify the password, view LED use time etc. And the pulse and level setting of each channel is also completed in this page, after modifying the working state of the light head, need to save the settings in order to make the setting become effective

 

3. 1Eight Channels Setting Interface First Interface

 

EightChannels Setting Interface Second Interface

 

 

 

FactorySetting Interface

In the Link Setting Interface, users can link numbers of channels to control easily. Users only need to open link switch, then operating one light head to control others.

 

 

LinkSetting Interface

 

Manual, automatic, advanced settings page

After entering each channel’s specific parameters setting page , there are three modes can be selected, select the appropriate mode to set specific parameters, after setting need to click “ Save setting ” on the lower right corner to make the settings effective, if click “ Returning “ on the upper right corner will not save the settings and configuration is still the old one

Manualmode settings interface

Automaticmode setting interface

 

 

 

Advancedmode settings interface

 

⑥ LED Working time state interface

 

5.1 Eight Channels Using Time Interface

 

○7 The corresponding serial number and definition of each pin are as follows:

NO.	Signal	Definition
1	CH1	Channel 1 start and stop signal
2	CH2	Channel 2 start and stop signal
3	CH3	Channel 3 start and stop signal
4	CH4	Channel 4 start and stop signal
5	COM1	Input common ground, the internal has been grounded
6	CH5	Channel 5 start and stop signal
7	CH6	Channel 6 start and stop signal
8	CH7	Channel 7 start and stop signal
9	CH8	Channel 8 start and stop signal
10	COM1	Input common ground, the internal has been grounded
11	EMER	Interlocking signal
12	COM1	Input common ground, the internal has been grounded
13	BUSY1	CH1 Irradiation Signal
14	BUSY2	CH2 Irradiation Signal
15	BUSY3	CH3 Irradiation Signal
16	BUSY4	CH4 Irradiation Signal
17	COM2	Output common ground
18	BUSY5	CH5 Irradiation Signal
19	BUSY6	CH6 Irradiation Signal
20	BUSY7	CH7 Irradiation Signal
21	BUSY8	CH8 Irradiation Signal
22	COM2	Output common ground
23	12V+	DC12V , max. current 100MA
24	12V-	DC12V , max. current 100MA